UV type fire detectors

Introduction

In process plants, sudden release of hydrocarbon / self igniting fluids may develop rapidly into a fire. In such cases it is imperative that fire is detected right at inception. Fire detectors are the devices which effectively carry out this task in this session we are going to discuss about UV type fire detectors

Working principle of UV type fire detectors

An ultraviolet (UV) radiation detector contains a sensor element (solid state or gas filled tube) that responds to a radiation band with a wavelength of less than 2800 m-10 (Angstrom). The sensor consists of a multiplier detector (usually Geiger Muller type ionization tube) mounted inside a metal housing with a quartz lens.

The amplification and monitoring circuits can be incorporated into the detector head, or located separately in a remote controller.

When ultraviolet radiation falls on the lens, the tube becomes conductive and activates the alarm control circuits. The effect of transient signals, such as lightning, can be eliminated by an integrated circuit.

UV radiation is strongly absorbed by smoke and, to some extent, by various vapors. UV detectors are highly susceptible to optical obstruction of the lens (eg, dirt, salt, oil mist).

They can capture welding radiation by electric arc at long distances even by reflection; they also respond to ionizing radiation (for example, non-destructive testing) and to reflected radiation from open flames (for example, reflection on the sea surface of flares).

The most commonly used UV detector has a lens control device (manually or automatically activated), which produces a fault signal when a certain threshold of darkening is reached. The sensitivity of the detector at this point is, however, unacceptably reduced for many fire protection applications

 

The typical UV detector is as shown is Fig.

UV type fire detectors

 

Ultraviolet light type detectors are also extremely fast in detecting fire but they should not be applied in dusty environments or in an environment with airborne oil droplets or where fires are expected to produce heavy smoke which may foul the lens. UV detectors are normally used, for example, for fire detection under the hood of gas turbines.

NOTE:

1) UV detectors are subject to interference from welding activities, X-rays used in non-destructive testing and lightning.

2) These detectors have an upper ambient temperature limit of 150 °C.

Area of Detection : Cone of sight

What are the different types of fire detectors?

Smoke alarms will detect most fires faster than heat detectors. There are currently three types of smoke alarms on the market: ionization, photoelectric and combined / photoelectric ionization. An ionization smoke alarm contains a small amount of radioactive material.Advantages of UV type fire detectors  :

1. Not affected by sunlight, or adverse weather

2. Detectors can be self testing

Limitations of UV type fire detectors  :

1. Spurious trips due to lightning, X-rays, welding and flares.

2. Dust, salt etc. on lens can hinder detection

3. Smoke absorbs UV light

Do you want to know about Working of Infrared Gas detector

News Reporter

Leave a Reply

%d bloggers like this: